We can offer extensive knowledge of the injection moulding process and tooling. Our in-house designers are fluent in the properties of most common polymers such as PC, ABS or Nylon etc.

Our selection of tooling materials is accurately matched with the polymer to be moulded, and projected maximum shot life to maximize productivity. We can provide various grades of soft tools for short production runs and prototyping to fully hardened multi-cavity tools which ensure accurate shots.

We offer“dual shot” moulding capability where lens or gaskets can be moulded into the plastic housings to ensure maximum IP ratings, reliable assembly and a reduction in component count.

PMSE uses a proven digital simulated program to observe the molding process to highlight and correct possible design faults, weak points and quality of the tools.

We pride ourselves on using the best branded raw materials for optimum performance and to ensure quality is delivered by minimizing the probability of regrind and cross contamination.